Other projects • Re: Custom Key pad

Once you've figured those out (and I'd wait a bit first) you could add more, although where would you put them? Punching more holes in the case is going to look ugly.

I'm modelling and printing my own panel to house everything with in the case so the drilled holes will be just for rivets or bolts holding it in place

In the meantime take a look at QMK. It would allow you to build a custom USB keyboard with rotary encoders too. It's interesting to read about, but a bit daunting at first.

It does look a little daunting but I will have a good look to under stand it as much as possible

Edited to add: I'm a bit busy today and tomorrow, so might not be able to do much. However, your plate is full getting the basics of Arduino running when it arrives

no worries , like you say I have lot to learn with the Arduino and I will continue to update the thread ready for when you get back , thanks again for what you have helped with so far, hope all goes well for you today and tomorrow

Statistics: Posted by tom2 — Wed May 22, 2024 7:05 pm

---