Might be worth reading https://pip.raspberrypi.com/categories/ ... idance.pdf
The DUAL-LANE DSI and the DUAL-LANE CSI are not available when you try to use a CM5 on a baseboard designed for CM4.
I have little to no intention to sort that out for waveshare boards as they have swapped labels on some of them (waveshare labeled the 4-lane CSI as CAM0 while it is CAM1 on the CM4).
--> check the pinout and connect the camera to the connector which uses the signals from the CM4's 4-lane interface.
Check which I2C port is used there and consider that (as you may need another overlay for swapping signals).
Check your board version and make sure you're looking at the correct schematic https://www.waveshare.com/wiki/CM4-IO-BASE-B
The DUAL-LANE DSI and the DUAL-LANE CSI are not available when you try to use a CM5 on a baseboard designed for CM4.
I have little to no intention to sort that out for waveshare boards as they have swapped labels on some of them (waveshare labeled the 4-lane CSI as CAM0 while it is CAM1 on the CM4).
--> check the pinout and connect the camera to the connector which uses the signals from the CM4's 4-lane interface.
Check which I2C port is used there and consider that (as you may need another overlay for swapping signals).
Check your board version and make sure you're looking at the correct schematic https://www.waveshare.com/wiki/CM4-IO-BASE-B
Statistics: Posted by aBUGSworstnightmare — Sat Jan 18, 2025 8:32 am
