I have a Raspberry Pi 4 connected to AV receiver for surround sound over PCM (intended for gaming over steamlink).
As with Bullseye, Bookworm does not map the speaker channels to the correct speakers until I change the config within
/usr/share/pulseaudio/alsa-mixer/profile-sets/default.conf
Following instructions here, I have successfully mapped the channels when using Bullseye 64 Bit.
viewtopic.php?t=331885
However, these same instructions do not work when apply the same config adjustment when using Bookworm 64 Bit.
Any ideas why this might be the case?
Thanks
As with Bullseye, Bookworm does not map the speaker channels to the correct speakers until I change the config within
/usr/share/pulseaudio/alsa-mixer/profile-sets/default.conf
Following instructions here, I have successfully mapped the channels when using Bullseye 64 Bit.
viewtopic.php?t=331885
However, these same instructions do not work when apply the same config adjustment when using Bookworm 64 Bit.
Any ideas why this might be the case?
Thanks
Statistics: Posted by daws0n — Mon Nov 25, 2024 10:20 pm
