Het onderstaande bericht plaatste ik op het Domoticz-forum, maar ik kreeg tot nu toe geen reactie.
Nu vraag ik mij af of het wel mogelijk is een image van een PImod3 100% te laten werken op een PImod4
Weet iemand daarop het antwoord?
Bedankt
==
I have domoticz 2024-7, zwave-js and Smartthings (via NodeRed) running on a raspberrypi Mod 3b.
I wanted to switch to a raspberry Mod 4 to speed up things so i made an image of the SD-card and put it in the Mod 4.
I took care that de Mod 4 used the same ip-adress as the old model Mod3b.
In my opnion nothing changed in the software config. Only the hardware changed.
Domoticz started as usual, all sensors worked, Smartthing switches worked but the zwave switches did not. The zwave js portal on port 8091 refused to open.
what am i missing?
and how to solve it?
==
Nu vraag ik mij af of het wel mogelijk is een image van een PImod3 100% te laten werken op een PImod4
Weet iemand daarop het antwoord?
Bedankt
==
I have domoticz 2024-7, zwave-js and Smartthings (via NodeRed) running on a raspberrypi Mod 3b.
I wanted to switch to a raspberry Mod 4 to speed up things so i made an image of the SD-card and put it in the Mod 4.
I took care that de Mod 4 used the same ip-adress as the old model Mod3b.
In my opnion nothing changed in the software config. Only the hardware changed.
Domoticz started as usual, all sensors worked, Smartthing switches worked but the zwave switches did not. The zwave js portal on port 8091 refused to open.
what am i missing?
and how to solve it?
==
Statistics: Posted by Paul37 — Fri Oct 04, 2024 8:41 am