Troubleshooting • Re: Which kernel to roll back to?

Code:

eth2: connecting (getting IP configuration) to Wired connection 3"ASIX AX88772"ethernet (asix), 00:0E:C6:75:B5:C7, hw, mtu 1500

So the device is recognised and configured as a network interface. Network Manager is trying to configure it with DHCP, but hasn't had a reply yet. That looks normal.

Perhaps so on Bookwork with NetworkManager, but not so on Bullseye without NetworkManager. I gather NM is waiting for a "carrier" from the attached dongle which is never going to happen (it times out eventually). However, the other device on eth1 succeeds. eth1 is not using a dongle, but is connected directly to an Analog Devices Pluto SDR - which apparently does maintain a "carrier". Again, both devices do connect on Bullseye.

Statistics: Posted by mbn — Mon Aug 12, 2024 12:57 pm

---