The Samsung card's CQ support should be silently discarded and basic read/write commands should be used. The filter I implemented is quite broad.That's concerning. Does that appear without sd_cqe in config.txt?Code:
[ 2.545617] mmc0: cannot verify signal voltage switch
Yes it does,
Code:
dmesg | grep mmc0[ 2.506024] mmc0: SDHCI controller on 1000fff000.mmc [1000fff000.mmc] using ADMA 64-bit[ 2.545602] mmc0: cannot verify signal voltage switch[ 2.623683] mmc0: new ultra high speed SDR104 SDXC card at address 59b4[ 2.653777] mmcblk0: mmc0:59b4 ED2S5 119 GiB[ 2.689491] mmcblk0: mmc0:59b4 ED2S5 119 GiB (quirks 0x00008000)Code:
cat /boot/firmware/config.txt # For more options and information see# http://rptl.io/configtxt# Some settings may impact device functionality. See link above for details# Uncomment some or all of these to enable the optional hardware interfaces#dtparam=i2c_arm=on#dtparam=i2s=on#dtparam=spi=on# Enable audio (loads snd_bcm2835)#dtparam=audio=on# Additional overlays and parameters are documented# /boot/firmware/overlays/README# Automatically load overlays for detected cameras#camera_auto_detect=1# Automatically load overlays for detected DSI displaysdisplay_auto_detect=1# Automatically load initramfs files, if foundauto_initramfs=1# Enable DRM VC4 V3D driverdtoverlay=vc4-kms-v3dmax_framebuffers=2# Don't have the firmware create an initial video= setting in cmdline.txt.# Use the kernel's default instead.disable_fw_kms_setup=1# Run in 64-bit modearm_64bit=1# Disable compensation for displays with overscandisable_overscan=1# Run as fast as firmware / board allowsarm_boost=1[cm4]# Enable host mode on the 2711 built-in XHCI USB controller.# This line should be removed if the legacy DWC2 controlleris required# (e.g. for USB device mode) or if USB support is not required.otg_mode=1[all]#dtparam=sd_cqedisable_splash=1camera_auto_detect=0dtparam=audio=offframebuffer_width=1600framebuffer_height=900dtoverlay=disable-wifidtoverlay=disable-btStatistics: Posted by The Olden Goat — Tue Jul 16, 2024 7:06 am