Hi all,
I'm rather new to this but have been putting together a retro game system on the raspberry pi 4. I have a prebuilt (jaycar) cabinet that is plug and pay and has gpio. I have used a pre built reteopie image and flashed and have got it to boot...only issue is it didnt recognise the controllers.
I worked out I needed to install gpionext on the image to get it to recognise and had some success. It now recognises most buttons and 3 of the 4 directional pad.
Issue is, whatever I do I cant get it to recognise the up direction pad and 2 buttons. When pushed no input at all (not in emustation or in gpionext).
I have tried another cabinet and it's exactly the same which makes me believe it is something with the image and configuration.
Any advice on what I could check?
Thanks
I'm rather new to this but have been putting together a retro game system on the raspberry pi 4. I have a prebuilt (jaycar) cabinet that is plug and pay and has gpio. I have used a pre built reteopie image and flashed and have got it to boot...only issue is it didnt recognise the controllers.
I worked out I needed to install gpionext on the image to get it to recognise and had some success. It now recognises most buttons and 3 of the 4 directional pad.
Issue is, whatever I do I cant get it to recognise the up direction pad and 2 buttons. When pushed no input at all (not in emustation or in gpionext).
I have tried another cabinet and it's exactly the same which makes me believe it is something with the image and configuration.
Any advice on what I could check?
Thanks
Statistics: Posted by Metallimax — Sun Jul 14, 2024 7:06 am