I tried the methods in viewtopic.php?t=150889&start=25, but I'm afraid it's out of date. I see you posted in it though!! You've been around a long time..
My setup is this:
config.txt:cmdline.txt:
config.dsi: config.hdmi:
My setup is this:
config.txt:
Code:
# For more options and information see# http://rptl.io/configtxt# Some settings may impact device functionality. See link above for details# Uncomment some or all of these to enable the optional hardware interfaces#dtparam=i2c_arm=on#dtparam=i2s=on#dtparam=spi=on# Enable audio (loads snd_bcm2835)dtparam=audio=on# Additional overlays and parameters are documented# /boot/firmware/overlays/README# Automatically load overlays for detected camerascamera_auto_detect=1# Automatically load overlays for detected DSI displaysdisplay_auto_detect=1# Automatically load initramfs files, if foundauto_initramfs=1# Enable DRM VC4 V3D driverdtoverlay=vc4-kms-v3dmax_framebuffers=2# Don't have the firmware create an initial video= setting in cmdline.txt.# Use the kernel's default instead.disable_fw_kms_setup=1# Run in 64-bit modearm_64bit=1# Disable compensation for displays with overscandisable_overscan=1# Run as fast as firmware / board allowsarm_boost=1[cm4]# Enable host mode on the 2711 built-in XHCI USB controller.# This line should be removed if the legacy DWC2 controller is required# (e.g. for USB device mode) or if USB support is not required.otg_mode=1[all]#ignore_lcd=1#[EDID=HDMI-A-1]#ignore_lcd=1#[EDID=DSI-1]#dtoverlay=vc4-kms-dsi-waveshare-panel,3_4_inchCode:
console=serial0,115200 console=tty1 root=PARTUUID=d2f31c3d-02 rootfstype=ext4 fsck.repair=yes rootwait cfg80211.ieee80211_regdom=US dsi Code:
display_default_lcd=1dtoverlay=vc4-kms-dsi-waveshare-panel,3_4_inchignore_lcd=1Code:
hdmi_force_hotplug=1display_default_lcd=0Statistics: Posted by xprxrxmxgwnx — Sat Jul 06, 2024 5:17 am