I have a question concerning Raspberry Pi 5. There is a section in the beginning of the assembly where it is noted that the Raspberry Pi 4 is not set to 5V by default and you have to solder a pin to get this set up properly. Is there any prep that needs to be done to add the Raspberry Pi 5 along this line?
I've posted the instructions for Pi 4 below for reference. I've got everything printed, the light board is in, but I'm stalling at this step as I don't want to cause any damage to the motors or any other parts. I haven't seen any information on you tube, in google or on OpenScan.eu. I have tried other ways to find the info. Thank you for your advice and instruction.
![Image]()
I've posted the instructions for Pi 4 below for reference. I've got everything printed, the light board is in, but I'm stalling at this step as I don't want to cause any damage to the motors or any other parts. I haven't seen any information on you tube, in google or on OpenScan.eu. I have tried other ways to find the info. Thank you for your advice and instruction.
Statistics: Posted by Prit2002 — Wed Jul 03, 2024 3:19 am