Supplying 5.1V to the 5V pins is fine. The recommended upper limit is 5.25V.
To kill your Pi you would have had to go higher than that voltage, or connect to the wrong pins.
What happens next depends on which Pi you were using. Some models have a TVS diode that protects against over-voltage by going short-circuit between 5V and ground.
To kill your Pi you would have had to go higher than that voltage, or connect to the wrong pins.
What happens next depends on which Pi you were using. Some models have a TVS diode that protects against over-voltage by going short-circuit between 5V and ground.
Statistics: Posted by rpdom — Fri May 03, 2024 6:58 pm
