Compute Module • Re: dtoverlay=i2c-fan,emc2301,i2c_csi_dsi fails to function with the latest kernel

Code:

# For more options and information see# http://rptl.io/configtxt# Some settings may impact device functionality. See link above for details# Uncomment some or all of these to enable the optional hardware interfacesdtparam=i2c_arm=on#dtparam=i2s=on#dtparam=spi=on# Enable audio (loads snd_bcm2835)dtparam=audio=on# Additional overlays and parameters are documented# /boot/firmware/overlays/README# Automatically load overlays for detected camerascamera_auto_detect=1# Automatically load overlays for detected DSI displaysdisplay_auto_detect=1# Automatically load initramfs files, if foundauto_initramfs=1# Enable DRM VC4 V3D driverdtoverlay=vc4-kms-v3dmax_framebuffers=2# Don't have the firmware create an initial video= setting in cmdline.txt.# Use the kernel's default instead.disable_fw_kms_setup=1# Run in 64-bit modearm_64bit=1# Disable compensation for displays with overscandisable_overscan=1# Run as fast as firmware / board allowsarm_boost=1[cm4]# Enable host mode on the 2711 built-in XHCI USB controller.# This line should be removed if the legacy DWC2 controller is required# (e.g. for USB device mode) or if USB support is not required.otg_mode=1dtoverlay=dwc2,dr_mode=host[all]enable_uart=1[all]# dtparam=i2c_vc=on#dtoverlay=i2c-fan,emc2301,i2c_csi_dsidtoverlay=i2c-fan,emc2301,i2c_csi_dsi,minpwm=0,maxpwm=255,midtemp=45000,maxtemp=65000# To endable the flashing of the eeprom uncomment the following#dtparam=spi=on#dtoverlay=audremap#dtoverlay=spi-gpio40-45